CyberData 011123x Operation Manual page 32

Installing the VoIP Indoor Intercom with Keypad (Flush-Mounted) 25
Parts List
Table 2-8. Device Configuration Parameters (continued)
Web Page Item Description
Click on the Test Microphone button to do a microphone
test. When the Test Microphone button is pressed, the
following occurs:
1. The device will immediately start recording 3 seconds of
audio.
2. The device will beep (indicating the end of recording).
3. The device will play back the recorded audio.
Click on the Test Relay button to do a relay test.
Click on the Start Button Test button to do a button test.
When pressed, the button text will change to Stop Button
Test and in this mode, pressing the button will play test
audio. Also, pressing this button also puts the device into a
mode where it will play audio as the buttons are pressed.
For buttons 0-9 it will play the audio file for that number.
For buttons '*', '#', and the Call Button, it will play the
appropriate DTMF tones.
Click the Save button to save your configuration settings.
Note: You need to reboot for changes to take effect.
Click on the Reboot button to reboot the system.
3. After changing the parameters, click the Save button.
Operations Guide 930370N CyberData Corporation