CyberData 011123x Operation Manual page 38

2.3.5.1 Point-to-Point Configuration
When the board is set to not register with a SIP server, it's possible to set the device to dial out to a
single endpoint. To do this, do the following:
1. On the SIP Configuration page
2. On the Button Configuration page
Note
Note
Note
Operations Guide
parameter is not selected.
remote device that you want to contact into a Keypad or Call Button field (in either Speed Dial
Mode or Security Dial Mode).
There is no way to place a point-to-point call in Telephone Dial Mode or Cellphone Dial
Mode. The Intercom can receive point-to-point calls in any mode.
The delayed DTMF functionality is available in the Point-to-Point Mode.
Establishing point-to-point SiP calls may not work with all phones.
Installing the VoIP Indoor Intercom with Keypad (Flush-Mounted)
(Figure 2-14), make sure that the Register with a SIP Server
(Figure 2-15 and
930370N
Figure 2-16), type the IP address of the
CyberData Corporation
31
Parts List