Calling Up A List - Mercedes-Benz COMAND Operating Instructions Manual

Displaying real-time traffic reports

Calling up a list

To switch to navigation mode: press the
X
Ø function button.
To show the menu: press W the COMAND
X
controller.
Select Traffic Traffic by turning cVd the
X
COMAND controller and press W to
confirm.
If the dialog field shows the "No Traffic
Messages" message, this means that:
no traffic reports have been received yet.
R
no traffic reports are available.
R
To cancel the search: select
X
press W to confirm.
To close the report window: select
X
and press W to confirm.
If traffic reports exist, a list is shown.
The content of the list varies depending on
whether route guidance is active or not.
List when route guidance is not active
The list shows all the roads, areas or regions
for which reports are available.
A traffic report may refer to an area or a
region, e.g. if visibility is impaired due to fog.
Calling up a list( page 95)
X
Y
To read a traffic report: select a road,
X
area or region by turning cVd the
COMAND controller and press W to
confirm.
List when route guidance is active
The first list shows the roads, areas and
regions that lie along the route and for which
traffic reports are available.
Call up a list (
X
Cancel Cancel and
To show all reports: select
X
Messages Messages
OK OK
controller and press W to confirm.
You see a list of all roads, areas and regions
for which traffic reports are available, even
if the reports do not affect your route.
To show a traffic report: select a road,
X
area or region and press W to confirm.
To close the list: slide XVY the COMAND
X
controller.
Traffic reports
page 95).
Y
Display All Display
by turning cVd the COMAND
95
All
Z