Setting Up Sequencing; Sequence Mode & Shift Mode - Digimerge DH200+R Series Instruction Manual

Setting up Sequencing

SETTING UP SEQUENCING
Sequencing allows you to view channels in a rotating interval. There are three modes of sequence
setup: sequence mode, shift mode, and event mode.
Sequence mode & Shift mode
Sequence mode allows you to display channels on a regular rotating interval. For example, the
monitor can display channels 1~4, then channels 5~8. Shift sequence mode retains the same split
screen view, but the channels in each cell continually increase by 1. For example, the monitor can
display channels 1~4, then channels 2~5.
To set up sequence mode:
1. Press the MENU button on the remote or front panel to open the main menu.
• If using a mouse, right-click to open the virtual remote, then click MENU.
2. Click DISPLAY.
Display
3. Click the SWITCH tab.
4. Beside DEVICE, select MAIN to configure the main monitor or SPOT to configure the spot
monitor. If you select SPOT, ensure a spot monitor is connected to the SPOT OUT port on the
rear panel.
5. Configure the following:
• DWELL TIME: Select the dwell time (the time duration before the channel changes).
• MODE: Select SEQUENCE or SHIFT.
• SPLIT MODE (MAIN configuration only): Select the desired split-screen style.
• USE CHANNEL: Select the channels you want to view in sequence view.
6. Press MENU on the remote or click ENTER
7. Exit to the main viewing window. Press and hold the DISPLAY button for 2 seconds on the
remote or front panel to begin sequence view. To exit sequence view, press DISPLAY on the
remote or front panel or press the camera number on the remote.
26
Switch
).
(