Day; Day Event - Digimerge DH200+R Series Instruction Manual

Using the Main Menu

DAY

Configuring the DAY tab
The DAY tab allows you to configure how the
system will record during Day recording in the
Scheduled recording menu.
To configure the DAY tab:
1. Click the DAY tab.
2. Beside the desired channel you wish to
configure, adjust the following for
Continuous and Event recording:
• Under F/S, select the frames per second
of the particular channel during Day
recording.
• Under QUALITY, select the recording
quality during daytime recording.
3. Click ENTER
(

DAY EVENT

Configuring the DAY EVENT tab
The Day Event tab allows you to configure how
the system will record an event if an alarm
trigger, motion or video loss occurs when the
DVR is in Day recording mode.
38
) to save your settings.
To configure the DAY EVENT tab:
1. Click the DAY EVENT tab.
2. Configure the following for each channel:
• ALARM: Select from 1~16 or ALL. This tells
the system to mark the video as an event
when an alarm input triggers for the
selected channel.
• VLOSS: Select a channel if you want the
camera to record when video loss occurs
on this channel, or select ALL for the
camera to record when video loss occurs
on any other channel. For example, if you
are configuring channel 1, and enter
channel 8 in the VLOSS column, this tells
the system that when a video loss occurs
in channel 8, it will also cause channel 1 to
record, and mark the recorded video as an
event.
NOTE: Even when OFF is selected, video loss
always causes an event on to occur on the
affected channel.
• : Indicates multiple devices are
configured (See About the "EVENT EDIT
window" below).
Event Edit icon