ASL INTERCOM VAR4 Operation Manual page 239

4. 4. Move to, and scroll the contact list until the required contact is displayed in the left field: Move to, and scroll the contact list until the required contact is displayed in the left field:
[Contact#nn] Not-Conf [Contact#nn] Not-Conf
Default value: Default value:
Contact numbers: Contact numbers:
Note: 'Not-Surv' is displayed to indicate that the digital input is not monitored. It is not configurable. Note: 'Not-Surv' is displayed to indicate that the digital input is not monitored. It is not configurable.
5. 5. Move to, and scroll the operation options until the 'Routing' option is displayed: Move to, and scroll the operation options until the 'Routing' option is displayed:
Contact#01 [Routing] Not-Surv Contact#01 [Routing] Not-Surv
Other options available: Other options available:
• •
External Fault External Fault
The contact is used as an external fault input. The contact is used as an external fault input.
See Section See Section "16.3.3 Configuring a Digital Input (Contact) as an External Alarm "16.3.3 Configuring a Digital Input (Contact) as an External Alarm
• •
Reset Contact Reset Contact
This contact was specified to act as the 'reset' contact of a contact configured to trigger a latched This contact was specified to act as the 'reset' contact of a contact configured to trigger a latched
latent route. It is not configurable from this sub-menu. latent route. It is not configurable from this sub-menu.
See Section See Section "16.3.2.3 Configuring a Routing Digital Input (Contact) for Latching "16.3.2.3 Configuring a Routing Digital Input (Contact) for Latching
6. 6. Save the changes by pressing the SELECT key and proceed with the remaining configuration in the Save the changes by pressing the SELECT key and proceed with the remaining configuration in the
following sections. Or cancel by pressing the BACK key. following sections. Or cancel by pressing the BACK key.
Make sure the selected contact is a Routing contact. Once the 'Routing' menu item is Make sure the selected contact is a Routing contact. Once the 'Routing' menu item is
!
!
selected, the contact will be configured for routing and the previous configuration will be selected, the contact will be configured for routing and the previous configuration will be
lost. lost.
VAR4 / VAR12 / VAR20 - Operation Manual
Not-Surv Not-Surv
'Contact#01' 'Contact#01'
01 to 12 01 to 12
Is sue: 03 complete, approved oved
Page 239 of 308 Page 239 of 308
Input". Input".
Mode". Mode".