8.
Move to, and scroll the option list until the 'Mic Routing' option is displayed in the middle field:
Button #01 [Mic Routing] Security
Other options available:
•
[Not-Conf]
The button is not used.
See Section
"7.3.4.1 Configuring a Button as
•
[DVA Routing]
Configures the selected button for complex routing.
See Section
"7.3.4.3 Configuring a Button for DVA
Note:
'DVA Routing' is only available for Paging or Zoned Fire Microphones that are connected
to VAR Router's Mic/Line inputs 1 or 2.
•
[AllCall]
Configures the selected button as 'All-Call' button.
See Section
"7.3.4.4 Configuring a Button as an All-Call
•
[{Route Reset}]
The selected button was specified to act as 'reset' button of a DVA Routing button configured to
trigger a latched route in the Latching menu. It is not configurable from this sub-menu.
See Section
"7.3.4.3.3 Configuring a DVA Routing Button for Latching
Note:
'Route Reset' is only displayed for Paging or Zoned Fire Microphones that are connected
to VAR Router's Mic/Line inputs 1 or 2.
Default value:
'Not-Conf'
9.
Press the SELECT key to display the output selection menu.
10. Move to, and scroll the output list until the required output is displayed in the left field:
[OUTPUT 01] Not Selected
Default value:
output 1 name
Outputs:
4 output for VAR4
12 output for VAR12
20 output for VAR20
Note: The output given above is the output 1 default name, however this may have been changed
according to each site's configuration.
11. Move to, and toggle to the required selection option in the right field:
•
[Not Selected]
The output is not part of the zone selection of the particular button.
•
[Selected]
The output is part of the zone selection of the particular button.
Default value:
'Not-Selected'
12. Repeat steps
10
to
13. Save the changes by pressing the SELECT key, or cancel by pressing the BACK key.
VAR4 / VAR12 / VAR20 - Operation Manual
11
to configure every output required for the zone selection of the particular button.
Is
sue: 03 complete, approved
Unused".
Routing".
Button".
Page 110 of 308
Mode".
Need help?
Do you have a question about the VAR4 and is the answer not in the manual?
Questions and answers