ASL INTERCOM VAR4 Operation Manual page 237

Other options available: Other options available:
• •
Routing Routing
The contact is used to trigger a latent route. The contact is used to trigger a latent route.
See Section See Section "16.3.2 Configuring a Digital Input (Contact) for "16.3.2 Configuring a Digital Input (Contact) for
• •
External Fault External Fault
The contact is used as an external fault input. The contact is used as an external fault input.
See Section See Section "16.3.3 Configuring a Digital Input (Contact) as an External Alarm "16.3.3 Configuring a Digital Input (Contact) as an External Alarm
• •
Reset Contact Reset Contact
This contact was specified to act as the 'reset' contact of a contact configured to trigger a latched This contact was specified to act as the 'reset' contact of a contact configured to trigger a latched
latent route. It is not configurable from this sub-menu. latent route. It is not configurable from this sub-menu.
See Section See Section "16.3.2.3 Configuring a Routing Digital Input (Contact) for Latching "16.3.2.3 Configuring a Routing Digital Input (Contact) for Latching
6. 6. Save the changes by pressing the SELECT key, or cancel by pressing the BACK key. Save the changes by pressing the SELECT key, or cancel by pressing the BACK key.
Make sure the selected contact is not used. Once the 'Unused' menu item is selected, the Make sure the selected contact is not used. Once the 'Unused' menu item is selected, the
! !
contact will be disconnected and the previous configuration will be lost. contact will be disconnected and the previous configuration will be lost.
Reference to Configuration Tool
VAR4 / VAR12 / VAR20 - Operation Manual
16.3.1
Is sue: 03 complete, approved
Page 237 of 308 Page 237 of 308
Routing". Routing".
DIGITAL INPUT
oved
Input". Input".
Mode". Mode".