Installing An Optional Remote Monitor Panel Ii - Eaton Power Xpert Plus 1 Installation And Operation Manual

INSTALLING OPTIONS AND ACCESSORIES
Table 5‐4. Pull-Chain Wiring Terminations with MOBs
From
UPS 1 CAN Bridge Card J3–1 (Alarm)
UPS 1 CAN Bridge Card J3–2 (Alarm Return)
UPS 1 TB2–1 (Pull Chain)
UPS 1 TB2–2 (Pull Chain Common)
UPS 2 CAN Bridge Card J3–1 (Alarm)
UPS 2 CAN Bridge Card J3–2 (Alarm Return)
UPS 2 TB2–1 (Pull Chain)
UPS 2 TB2–2 (Pull Chain Common)
UPS 3 CAN Bridge Card J3–1 (Alarm)
UPS 3 CAN Bridge Card J3–2 (Alarm Return)
UPS 3 TB2–1 (Pull Chain)
UPS 3 TB2–2 (Pull Chain Common)
UPS 4 CAN Bridge Card J3–1 (Alarm)
UPS 4 CAN Bridge Card J3–2 (Alarm Return)
UPS 4 TB2–1 (Pull Chain)
MOB 1 Aux 2 Com
MOB 2 Aux 2 Com
MOB 3 Aux 2 Com
5.3

Installing an Optional Remote Monitor Panel II

t
5-8
Power Xpert 9395 UPS (450–550 kVA) Installation and Operation Manual
To
MOB 1 Aux 1 NC
MOB 1 Aux 1 Com
MOB 1 Aux 2 NO
UPS 2 TB2–2 (Pull Chain Common)
MOB 2 Aux 1 NC
MOB 2 Aux 1 Com
MOB 2 Aux 2 NO
UPS 3 TB2–2 (Pull Chain Common)
MOB 3 Aux 1 NC
MOB 3 Aux 1 Com
MOB 3 Aux 2 NO
UPS 4 TB2–2 (Pull Chain Common)
MOB 4 Aux 1 NC
MOB 4 Aux 1 Com
MOB 4 Aux 2 NO
MOB 2 Aux 2 Com
MOB 3 Aux 2 Com
MOB 4 Aux 2 Com
To install RMP II wiring:
1. Verify the UPS system is turned off and all power sources are removed. See
Chapter 7, "UPS Operating Instructions," for shutdown instructions.
2. Perform the procedure listed in paragraph 5.1.
NOTE If mounting to a hollow wall, secure the enclosure to a wood or metal stud within the wall. Do not
use hollow wall anchors.
3. Securely mount the RMP II at the desired location. See Figure 5‐12 on page 5-15
for mounting hole locations.
Pull Chain Common
Pull Chain Common
Pull Chain Common
Pull Chain MOB Common
S
164201701 Rev 3 www.eaton.com/powerquality
Function
MOB Open Alarm
Pull Chain
MOB Open Alarm
Pull Chain
MOB Open Alarm
Pull Chain
MOB Open Alarm
Pull Chain