Maintenance; Before You Begin - Precor Discovery Series Selectorized Line Owner's Manual

Maintenance

Before You Begin

Precor recommends implementing a thorough maintenance program that
incorporates regular safety inspections by qualified maintenance technicians
as outlined in this manual.
This manual explains how to maintain the Precor Discovery Selectorized Line
of commercial strength equipment. It provides information about items that
need to be inspected and maintained on a daily, weekly, monthly, and annual
basis. You should perform those tasks that are appropriate for the equipment
you are maintaining, and skip those tasks that do not apply.
This manual covers the general maintenance procedures that you can perform
in the fitness facility. However, if the equipment requires service beyond the
maintenance procedures covered in this manual, refer to Obtaining Service.
Important: Always purchase replacement parts and hardware from Precor. Many
parts are tested and manufactured specifically for Precor commercial strength
equipment. If you use parts not approved by Precor, you could void the Precor
Limited Warranty. Use of parts not approved by Precor may cause injury.
Precor recommends that maintenance technicians thoroughly read and
understand the safety guidelines and maintenance procedures covered in this
manual.
Note: If the equipment requires assembly, a separate assembly guide is
provided. For information on how to use a piece of equipment, refer to the
instructional label found on the equipment and the Product Specifications and
Use section in this manual.
Discovery Selectorized Line Owner's Manual: Maintenance
Recommended Tools
We recommend that you keep the following tools available to inspect and
maintain the equipment:
 Complete combination box wrench set from ¹⁄₂-inch to ¹⁵⁄₁₆-inch
 Complete socket set from ¹⁄₂-inch to ¹⁵⁄₁₆-inch
 Hex nut driver: ¹⁄₄-inch
 Adjustable 12-inch wrench
 Complete hex key set from ⁵⁄₆₄-inch to ³⁄₈-inch
 Rubber mallet
 Phillips head screwdriver

³⁄₁₆-inch hex key wrench (ball end or T-handle)
29