Precor Discovery Series Assembly Manual
Plate loaded
Hide thumbs
Also See for Discovery Series:
- Owner's manual (44 pages) ,
- Assembly manual (12 pages) ,
- Getting started manual (2 pages)
Subscribe to Our Youtube Channel
Related Manuals for Precor Discovery Series
Summary of Contents for Precor Discovery Series
- Page 1 Discovery™ Series Plate Loaded 624 SQUAT MACHINE ASSEMBLY GUIDE ©2019 Precor Incorporated P/N CW39176-113, ENU November 21, 2019...
-
Page 4: Hardware Kit
Hardware kit Socket head bolt (M8 x 25 mm) Hardware Hardware Name Quantity Socket head cap bolt (M12 × 35 mm) Flat washer (9 x 16 mm) Flat washer (13 x 26 mm) TPU (rubber bumper) washer Socket head cap bolt (M12 × 25 mm) Button head bolt (M10x16 mm) Socket head cap bolt (M12 ×... -
Page 5: Assembly Requirements
Assembly requirements Begin Assembly NOTE DO NOT fully tighten the fasteners until instructed to do so. Precor recommends at least two people for this installation. Remove shoulder pad pivot support Disconnect the pre-assembled shoulder pad assemblies (Figure 1). DO NOT attempt assembly by yourself. - Page 6 Attach moving arms 7. Repeat step 4 to attach the other shoulder pad assembly. Test each moving arm to make sure it moves smoothly 1. Position the weight arm pivot tube in line with the bottom holes in the rear upright through its range of motion.
- Page 7 Assemble height calibration Attach foot plate 1. Place a bumper on either side of the height 1. Position the foot plate onto the base frame. adjustment assembly bottom rod end and pos- 2. Secure the plate using two bolts (Figure 14). Fully ition it inside of the weight arm bracket (Figure tighten the bolts.
- Page 8 CAUTION Standards occasionally change or are updated. Precor recommends that you keep apprised of your local industry standards. Precor shall not be held liable for failure to properly bolt the strength equipment to the floor.
Need help?
Do you have a question about the Discovery Series and is the answer not in the manual?
Questions and answers