D Adjusting White Balance <White Balance; Awc (One-Push); Mwb (Manual White Balance) - Sanyo VCC-P6784 Instruction Manual

Setting Camera Performance
· SYNC
BLC
IRIS
D
WHITE BALANCE
E
AGC GAIN
F
GAMMA
G
SHUTTER
H
APERTURE
OPTION
D Adjusting White Balance
With its default Auto-tracing White Balance (ATW) setting, this unit
is able to obtain natural colors even when the light source is
changed. However, you may manually change the white balance
settings or its mode to obtain better tone, especially when the
screen color does not match actual objects.
■ ATW (Auto-Tracing White balance)
Automatic setting for white balance.
■ AWC (One-Push Adjustment)
Adjusts white balance by shooting white paper or wall.
■ 3200 (Halogen light or incandescent lamp, etc.) (Fixed)
Targeted at around 3200 K of color temperature.
■ 5600 (Daytime sunlight) (Fixed)
Targeted at around 5600 K of color temperature.
■ FLUO (Fluorescent lamp) (Fixed)
Targeted at around 4200 K of color temperature.

■ MWB (Manual White Balance)

Fine-adjusts red and blue manually.
19
GB
L-L
y
OFF
SET y
ATW
NORM
0.45
60
HIGH
y
SET
<WHITE BALANCE>

AWC (One-Push)

Select [AWC LOCK] and, with the camera lens directed toward a
white paper or wall, press the SET button.
AWC SETTING
· AWC LOCK SET
GO TO MWB SET y
RThe cursor "q" lights off, and white balance adjustment will start. The
adjustment will end after about 2 seconds when "q" lights again.
• If the adjustment does not yield a satisfactory result, press the SET
button again.
■ To perform fine adjustment of color
Select [GO TO MWB] and press the SET button.
R The MWB SETTING screen appears. Follow the MWB SETTING
procedure below.
• The setting mode changes to "MWB".
MWB (Manual White Balance)
Select "R" or "B" to adjust tint (0 – 255).
MWB SETTING
· R 43
B 66
White paper or wall
R : Adjusting Red
B : Adjusting Blue
• The greater the number, the
deeper the tint becomes.