Polycom KIRK 8000 Configuration Manual page 84

Polycom, Inc.
Hold down the Shift key and then press the Z key. A command prompt is
4
displayed.
In the prompt type loadb and then press Enter. The following text is
displayed in the command prompt.
## Ready for binary (kermit) download to 0x00010000 at 115200 bps...
From the Transfer menu, select Send File.
5
Select the uimage file you want to download, in the protocol item select
6
Kermit, and then click the Send button.The following text is displayed on
completion. Note that
## Total Size
## Start Addr
Note the Total Size may vary from uimage to uimage.
Note The Total Size may vary from uimage to uimage. 0x00231708 is an
example. You must always use the correct image size.
Type protect off 1:1-63 and then press Enter. The following text is
7
displayed on completion.
Un-Protect Flash Sectors 1-63 in Bank # 1
Type erase 1:1-63, and then press enter. The following text is displayed
8
completion.
Erase Flash Sectors 1-63 in Bank # 1
.............................................................. done
Type cp.b 0x10000 (Start Addr) 0x50020000 <Total Size> where the last
9
number must be the TotalSize of the uimage (in this example
All numbers are in hexadecimal.
10 Press Enter. The following text is displayed on completion.
Copy to Flash... done
11 Type boot and then press Enter. The system restarts.
= 0x00231708 = 2299656 Bytes
= 0x00010000
Updating Software Manually
.
0x231708)
79