Pc Installation - Korenix JetPort 5208 User Manual

PC Installation

Refer to the Installation Diagram on p.10 (the numbers in the diagram
correspond to the numbers of the steps), as you do the following:
1. For each server or serial device, plug an RJ45 to Serial cable into its serial
port.
2. Plug the RJ-45 connector of the cable above to connect any available port
on the JETPORT 5208 / JETPORT 5216's rear panel to the adapter.
3. If you choose to install a serial modem for OOB operation (see Chapter 6),
use standard Ethernet cable to connect any available port on the JETPORT
5208 / JETPORT 5216's rear panel to a DTE to DCE serial Cable then
plug the cable into the modem's serial port.
Note: This step is optional.
4. Plug a Ethernet cable to connects the JETPORT 5208 / JETPORT 5216 to
the network or the Internet into its LAN port.
5. Use the AC power cord provided with this package to connect the
JETPORT 5208/ JETPORT 5216's Power Socket to an AC power source.
After you connect all the cables, you can turn on the JETPORT 5208 /
JETPORT 5216.
Chapter 2. Hardware Setup
9