Indirect Ppp Connection; Setup - Korenix JetPort 5208 User Manual

Indirect PPP Connection

This method uses a modem connection to phone into the JETPORT 5208 /
JETPORT 5216 from a remote location.

Setup:

1. Set up your hardware configuration to match the diagram, below:
Serial Modem Cable
Remote
Operator
Modem
On the remote computer side, use a standard 9 pin serial modem cable
(pin 2 to pin 2; pin 3 to pin 3) to connect the computer to the modem.
On the JETPORT 5208 / JETPORT 5216 side, use Cat 5 cable and an
Optional: RJ-45 to Serial Cable
Note: Be sure that the port you specify as the Console Port in the OOBC
dialog box matches the port that you connect the modem to. Change
the setting, if necessary.
2. Set up your connection configuration as specified in Steps 2 - 8 of the
Direct Dial In Connection, section.
3. For Step 9, key in the JETPORT 5208 / JETPORT 5216's modem
telephone number in the fields provided, then click Next.
4. Click Finish.
A new icon that you can use to connect to the JETPORT 5208 / JETPORT
5216 is created in the Dial-up Network folder. This completes the Indirect
Dial In setup.
Chapter 6. Out of Band Operation
JETPORT 5208 / JETPORT 5216
Ethernet to
Serial
Phone Line
cable
Modem
59