Korenix JetPort 5208 User Manual page 34

JetPort 5208/JetPort 5216 User's Manual
(Continued from previous page.)
Setting
Operating Mode The choices are:
Console Management: In this mode, users establish a
Telnet or SSH session under the JETPORT 5208 /
JETPORT 5216 to manage a server or serial device
connected to the port. Users can log in using the
browser Telnet function, a direct Telnet session, SSH or
PuTTY. This mode can also be used for Out-of-Band
operation via the JETPORT 5208 / JETPORT 5216's
Console Port. See Out of Band Operation, Chapter 6.
Raw TCP Mode: This mode is used with socket
programming to directly control the device's data
transmission without the need for serial port control or
serial modem signal control. Only data is transmitted
(using IP as the protocol).
Note: When you use the IP address you must also
specify the port number. For example:
192.168.0.200 5003.
For security purposes, access to the port can be limited
to specific IP addresses. See Direct Access
Real COM Port: Used with a Real COM port driver on the
local machine (See Real Port Management, Chapter 7
for Real port management details.) The device
connected to this port appears as if it were a device
directly connected to a COM port on the local computer.
Data transmission between the device and the local
computer takes place over the Real COM port to the
JETPORT 5208 / JETPORT 5216.
This mode is useful with serial devices such POS
terminals, Bar Code Readers, Serial printers, etc.
As with Raw TCP Mode, access to the port can be
limited to specific IP addresses with the Direct Access
function.
2
Meaning
(Continues on next page.)