JetPort 5208/5216 User's Manual
Indirect HyperTerminal Connection
This method uses HyperTerminal to phone into the JETPORT 5208 /
JETPORT 5216 from a remote location.
Setup:
1. Set up your hardware configuration to match the diagram, below
Serial Modem Cable
Remote
Operator
Modem
On the remote computer side, use a standard 9 pin serial modem cable
(pin 2 to pin 2; pin 3 to pin 3) to connect the computer to the modem.
On the JETPORT 5208 / JETPORT 5216 side, use Cat 5 cable and an
Note: Be sure that the port you specify as the Console Port in the OOBC
dialog box (see p. 22) matches the port that you connect the modem
to. Change the setting, if necessary.
2. Create a HyperTerminal connection.
a) Start with Step 2 of the Direct HyperTerminal Setup section (p. 47).
b) For Connect using: in Step 4, select the type of modem connected to
your computer from the list. If your modem doesn't appear in the list,
select Standard 28800bps Modem.
c) Follow Steps 5-9 to complete the setup and create the connection icon.
52
:
JETPORT 5208 / JETPORT 5216
Ethernet to
Phone Line
Modem
Serial
Cable