Hardware Installation
Panel and Interfaces
Auto MDI/MDIX
10/100M Ethernet
Built-in 1.5 KV magnetic
Reset Button
Reset IP address and
configuration to default
Power/Ready LED
Ethernet Link/Act LED
Serial TX/RX LED
1 RS-232 port, DB9
15 KV ESD for all signals
110 bps to 460.8 Kbps
Reset Button
The Reset button provides users with a quick and easy way to restore the default settings of
JetPort. Press reset button for 10 seconds. Release after Power LED blinking orange. JetPort
will restore to default value including default IP address (192.168.10.2), and no password. When
the Power LED turns green, the device is ready to function.
LED Indicators
There are 3 LEDs, indicating real-time system status.
LED
PWR/
Ready
Link / ACT
TX / RX
2-2
Color
Indication
Red
On: Power is on and booting up.
Blinking: Indicates an IP conflict, or DHCP or BOOTP server did not
respond properly.
Green
On: Power is on and functioning normally.
Blinking: Located by Administrator's Location function.
Off
Power is off, or power error condition exists.
Green
Blinking: 10 /100Mbps Ethernet connection.
Off
Ethernet cable is disconnected, or has a short.
Orange
Serial port is receiving data.
Green
Serial port is transmitting data.
JetPort Serial Device Server User's Manual
12VDC (9~30 VDC)
1 KV Burst (EFT), EN61000-4-4
0.5 KV Surge, EN61000-4-5
Mounting kit