Sun Fire V100 Server Installation - Korenix JetPort 5208 User Manual

Sun Fire V100 Server Installation

For each Sun Fire V100 server you wish to install, refer to the Installation
Diagram on p. 12 (the numbers in the diagram correspond to the numbers of
the steps), as you do the following:
1. Use standard Ethernet cable to connect any available port on the JETPORT
5208 / JETPORT 5216's rear panel.
2. Use standard Ethernet cable to connect the V100's LAN port.
Note: If you choose to install a serial modem for OOB operation
(see Chapter 6), refer to step 3 of the PC installation procedure.
4. Plug the cable that connects the JETPORT 5208 / JETPORT 5216 to the
network or the Internet into its LAN port.
5. Use the AC power cord provided with this package to connect the
JETPORT 5208/ JETPORT 5216's Power Socket to an AC power source.
After you connect all the cables, you can turn on the JETPORT 5208 /
JETPORT 5216.
Chapter 2. Hardware Setup
1