Arriva 752 Installation - Rinnai Arriva 752 Installation Manual

Arriva 752 installation

Isolate the electrical supply before removing any panels.
WARNING
Gas pipe connection
1
a. Remove the RHS access panel by removing
the four retaining screws.
b. Extend the flexible gas connection through
the gas fitting access point to the outside of
the heater body.
c. Position the unit in front of the enclosure so
the end of the gas pipe aligns with the gas
fitting access point.
d. Securely connect the flexible gas
connection, testing all connections for gas
leaks.
e. Replace and secure the RHS access panel.
Open flue and air hose access
2
a. Unscrew the flue access panel and remove
the clamp that secures the telescopic
vertical flue pipe to the telescopic
horizontal flue pipe.
b. Clamp the original flue pipe to the flue
transition box using the flue retainer
bracket (supplied in the plastic bag with the
remote control), OR the flue slide stopper
(provided with the ASPDFK and ASPKIT03
flue kits). The clamping component will
differ depending on the flue configuration.
c. Fasten the air inlet hose to the transition
box using the cable tie supplied in the
accessory pack with the remote.
d. Push the unit into position. Adjust
horizontal and vertical telescopic flue pipe,
and connect using the clamp.
e. Replace the flue access panel.
10 | Arriva 752 Installation Guide: 12218-F 06-18
1a
Access
panel
screws
2a
Screws
Access
panel
Telescopic horiz. flue pipe
2b
Lower
elbow Clamp
Telescopic vertical flue
pipe
2c 2d
Air inlet hose
Telescopic horiz. flue pipe
Transition
box
Flue slide stopper
(ASPDFK & ASPKIT03)
Telescopic
vertical flue pipe
Clamp