Safety Requirements / Specifications - kozy heat TMT-3875 Installation And Operating Manual

READ THIS MANUAL BEFORE INSTALLING AND USING THIS FIREPLACE
'TRIMONT' DIRECT VENT SEE-THRU / PIER GAS FIREPLACE
This fireplace has been tested to and complies with ANSI Z21.88B-2005
by OMNI-Test Laboratories, Beaverton, OR. Installation must conform with local building codes or in the absence of local building
codes, with the National Fuel Gas Code, ANSI Z223.1/ NFPA 54 - Current Edition, or the Natural or Propane Installation Code, CSA
B149.1.
COMMONWEALTH OF MASSACHUSETTS
INSTALLATIONS
WARNING: This Product Must Be Installed By A Licensed
Plumber Or Gas Fitter When Installed Within The
Commonwealth of Massachusetts.
IMPORTANT: Installation of a CO detector is required in
the fireplace room.
WARNING: Do not use this fireplace if any part has been
under water. Immediately call a qualified service technician
to inspect this appliance and to replace any part of the
control system and any gas control which has been under
water.
INSPECT THE FIREPLACE & ALL COMPONENTS
Inspect the fireplace, vent system & all components. Contact your dealer if any parts are damaged or missing. Do not
install the fireplace with damaged, incomplete, or substitute parts.
PLANNING THE INSTALLATION
Prior to installation of this fireplace, the following must be considered:
See-Thru or Pier Installation.
‚
‚ Location of fireplace.
‚ Configuration of vent system.
Gas piping.
‚
‚ Electrical wiring - Model #TMT-3875-RF, optional for Model #TMT-3875.
‚ Framing.
Hearth height, width & depth. NOTE: A hearth is not required.
‚
‚ Materials used for finishing the fireplace.
‚ Optional accessories used: Fan, wall switch, remote control, thermostat, etc..
NOTE: When the fireplace is installed directly on carpeting, tile, or other combustible materials other than wood flooring, it must
be installed on a metal or wood panel extending the full width and depth of the fireplace. The minimum for the support platform
under the fireplace 38 3/4" wide by 24" deep.
If masonry is to be used (optional), prepare the necessary foundation for the masonry load. When masonry construction is being
used, a lintel must be used over the top of the fireplace to support the added weight.
IMPORTANT:
CSA 2.33B-2005 "VENTED GAS FIREPLACE HEATERS"

DO NOT REPLACE THIS BURNER UNIT WITH ANY
OTHER SIZED BURNER. REPLACEMENT WITH AN
UNAUTHORIZED
TEMPERATURES EXCEEDING THE LIMITS FOR THIS
FIREPLACE, AND VOID YOUR WARRANTY.
IMPORTANT: NON-COMBUSTIBLE FACING MATERIAL
MAY BE APPLIED OVER THE FACE. TO PREVENT THE
FACING MATERIAL FROM CRACKING AND FALLING
OFF DUE TO EXPANSION OF THE FACE WHEN
HEATED, DO NOT ATTACH FACING MATERIAL
DIRECTLY TO THE FACE OF THE UNIT.
OBSTRUCT THE FLOW OF VENTILATION AIR.
CONSULT YOUR LOCAL OR NATIONAL INSTALLATION
CODES TO ASSURE THAT ADEQUATE COMBUSTION
AND VENTILATION AIR IS AVAILABLE.
Page 1
WARNING:
BURNER CAN RESULT
DO NOT
IN