Fireplace Insert Specifications; Safety Requirements - kozy heat 911-XXL Installation & Operating Manual

DIRECT VENT GAS BURNING FIREPLACE INSERT
READ THIS MANUAL BEFORE INSTALLING AND USING THIS FIREPLACE
This fireplace has been tested to and complies with ANSI Z21.88-2002
OMNI-Test Laboratories, Beaverton, Oregon for U.S. Installations only. Installation must conform with local building codes or in
the absence of local building codes, with the National Fuel Gas code, ANSI Z223.1 NFPA 54 - Current Edition.
SPECIFICATIONS:
Height (top of firebox): 25 1/4"
Width: 38 1/4" Back Width: 26 1/4"
NOTE: Minimum existing opening width required: 38 1/2"
Do not use this fireplace if any part has been under water.
Immediately call a qualified service technician to inspect
this appliance and to replace any part of the control
system and any gas control which has been under water.
WARNING: DO NOT REPLACE THIS BURNER WITH ANY
OTHER SIZED BURNER.
UNAUTHORIZED BURNER CAN RESULT IN TEMPERATURES
EXCEEDING THE LIMITS FOR THIS FIREPLACE AND VOID
YOUR WARRANTY.
DUE TO HIGH TEMPERATURES, THIS FIREPLACE SHOULD
BE LOCATED OUT OF TRAFFIC AND AWAY FROM
FURNITURE AND DRAPERIES
The efficiency rating of this appliance is a product
thermal efficiency rating determined under continuous
operating conditions and was determined independently
of any installed system.
MODEL JACKSON XXL
INSTALLATION & OPERATING INSTRUCTIONS
IMPORTANT:
Height (top of air duct): 27 1/2"
Depth: 16 1/8"
REPLACEMENT WITH AN
CSA 2.33-2002 "VENTED GAS FIREPLACE HEATERS" by

YOUNG CHILDREN SHOULD BE CAREFULLY SUPERVISED
WHEN THEY ARE IN THE SAME ROOM AS THIS FIREPLACE.
CHILDREN AND ADULTS SHOULD BE ALERTED TO THE
HAZARDS OF HIGH SURFACE TEMPERATURE AND
SHOULD STAY AWAY TO AVOID BURNS OR CLOTHING
IGNITION.
CLOTHING OR OTHER FLAMMABLE MATERIAL SHOULD
NOT BE PLACED ON OR NEAR THE APPLIANCE.
COMMONWEALTH OF MASSACHUSETTS INSTALLATIONS
WARNING: This Product Must Be Installed By A Licensed Plumber Or
Gas Fitter When Installed Within The Commonwealth of Massachusetts.
IMPORTANT: Installation of a CO detector is required in the fireplace
room.
Page 1