Safety Requirements - kozy heat 944 SEE-THRU Installation & Operating Instructions Manual

READ THIS MANUAL BEFORE INSTALLING AND USING THIS FIREPLACE
This appliance has been tested to and complies with ANSI Z21.88-2002CCSA 2.33-M02 'VENTED GAS FIREPLACE
HEATER'. Installation must conform with local building codes, or, in the absence of local building codes, with the
National Fuel Gas Code, ANSI Z223.1-NFPA 54 (Current Edition). Approved for U.S. Installations only.
This appliance may be installed in an after-market permanently located, manufactured (mobile) home, where not prohibited by local
codes.
This appliance is only for use with the type(s) of gas as indicated on the rating plate. This appliance is not
other gases, unless a certified kit is used. An LP Gas conversion is included with this fireplace.
WARNING: If the information in these instructions are not followed exactly, a fire or explosion may
result, causing property damage, personal injury or loss of life.
 Do not store or use gasoline or other flammable vapors and liquids in the vicinity of this or any
other appliance.
WHAT TO DO IF YOU SMELL GAS:
‚ Do not try to light any appliance.
‚ Do not touch electrical switches; do not use the phone in your building.
‚ Immediately call your gas supplier from a neighbor's phone. Follow the gas supplier's
instruction.
‚ If you cannot reach your gas supplier, contact the fire department.
‚ Installation & service must be performed by a qualified installer, service agency or the gas
supplier.
COMMONWEALTH OF MASSACHUSETTS
INSTALLATIONS:
WARNING: This Product Must Be Installed By A Licensed
Plumber Or Gas Fitter When Installed Within The
Commonwealth of Massachusetts.
IMPORTANT: Installation of a CO detector is required in
the fireplace room.
WARNING: Improper
alteration, service or maintenance can cause injury,
property damage, or loss of life. Refer to this manual
for assistance. For additional information, consult a
qualified installer, service agency or the gas supplier.
IMPORTANT:
KOZY HEAT MODEL #944 DIRECT VENT
See-Thru / Pier Fireplace
INSTALLATION INSTRUCTIONS
installation, adjustment,
WARNING: Do not use this appliance if any part has
been under water.
service technician to inspect the appliance and to
replace any part of the control system and any gas
control which has been under water.
NOTE: THIS FIREPLACE REQUIRES A DIRECT
VENT KIT FOR INSTALLATION.
PAGE #3 FOR APPROVED SYSTEMS LISTING.
FOR VISUAL INSPECTION OF PROPER VENT
CONNECTION,
INSTALLING THE DIRECT VENT KIT, REMOVE
THE NUTS AND BAFFLE INSIDE THE UNIT TO
EXPOSE THE LOWER END OF THE FLUE GAS
EXIT.
Page 1
convertible for use with
Immediately call a qualified
REFER TO
UPON COMMPLETION OF