Loewe Connect ID 46 Operating Instructions Manual page 67

Connect ID 32-46
Operating instructions
Media +
Configuration of the built-in LAN adapter
➠ Adapter configuration is accessed over the media
menu (see page 66).
You will see an overview of the current settings for the
selected network adapter (for an explanation of the
points, see page 68).
NETWORK WIZARD: WIRED
Current adapter settings:
IP configuration
IP address
Subnet mask
Gateway
DNS server 1
DNS server 2
Additional adapter data:
MAC address
Change settings
OK
OK Change settings for the network adapter.
Select type of IP configuration.
Manual:
Automatic:
OK Proceed.
If manual has been selected under IP configuration:
Enter IP, Subnet mask, Gateway and DNS server
addresses in succession with the numeric keys on
the remote control.
OK Proceed.
You will now see an updated overview of the settings
for the network adapter.
OK End of wizard.
Manual
192.168.2.123
255.255.255.0
192.168.2.1
192.168.2.1
192.168.2.1
00:09:82:11:99:11
Enter your fixed static IP address manu-
ally (see below).
Automatic configuration of the IP address
via DHCP server or via multiple protocols
according to UPnP specification (including
DHCP).
- 67 -
Configuration of a wireless adapter (e.g. WLAN bridge adapter)
➠ Adapter configuration is accessed over the media
menu (see page 66).
You will see an overview of the current settings of the
network adapter (similar to the illustration in the left-
hand column).
OK Change settings for the network adapter.
The TV set now searches for wireless routers.
Red button: Stop search.
After the end of the search:
OK Proceed.
If the desired access point is not found:
Red button:
Yellow button: Specify base station manually, e.g. if the
OK Proceed.
If your wireless network has an encryption, select the
encryption method and then enter the WLAN password
(procedure same as for Rename station, see page 47).
➠ Contact your network administrator if you do not
know the WLAN code.
➠ For encryption types supported, see page 142.
For WEP encryption:
OK Proceed.
You will now see an updated overview of the settings
for the network adapter.
OK End of wizard.
Select required base station from the options
found.
Repeat the search. Or:
SSID of the access point is not trans-
ferred. Same procedure as for Rename
station, see page 47.
Select the WEP index,
Select type of IP configuration (see left column).