Loewe Connect ID 46 Operating Instructions Manual page 7

Connect ID 32-46
Operating instructions
For your safety
TV sets with 3D function
Read the following safety instructions before using the 3D function of
your TV set.
Please only use Loewe 3D glasses (see Accessories on page 143) in
conjunction with Loewe 3D TV sets.
People that have a visual disorder may not be able to perceive 3D effects
or may only be able to perceive them to a limited extent. People that
are sensitive to flickering images (e.g. those with epilepsy) should only
use this product after having consulted their doctor.
It might take some time for you to get used to the 3D glasses and before
you can perceive the 3D effects properly.
Stop using the 3D devices immediately if you experience any feelings of
nausea, dizziness or malaise when viewing 3D content.
Supervise children whilst they are viewing 3D content, as they can be
particularly sensitive to it.
Allow more time for a break when viewing 3D films, so that you are
able to relax. Failure to do this could result in headaches, fatigue, diz-
ziness or malaise.
Position yourself comfortably in front of the 3D TV set and ensure that
you are seated firmly. By doing this, you will avoid any injuries that may
arise due to reacting to extreme 3D content.
Switch off any artificial light sources (e.g. energy saving lamp) between
the TV set and the 3D glasses. These could impair the infrared reception
or the TV picture may flicker as a result.
Installation
The set is suitable for mounting in many different ways. Note the assembly
instructions regarding the different possible mounting options.
Stand the TV set with the table or floor stand only on a level, sturdy,
horizontal base. Particularly ensure that the set does not protrude to
the front when placed in or on pieces of furniture.
Place the TV set in a normal position for use. The TV set may only be
used in an upright horizontal position. It may not be tilted by more than
10 degrees. The TV set must never be operated vertically, lying flat or
hanging overhead from the ceiling.
±10°
Set up the device where it is not exposed to direct sunlight and where
it is not exposed to additional warming through heating elements.
Repairs and accessories
Never remove the back of the TV set yourself. Only have your TV device
repaired or serviced by authorised television technicians.
Only use original accessories such as Loewe stands if possible (see Acces-
sories on page 143.
Supervision
Do not allow children to use the TV set without supervision or to play
in the immediate vicinity of the TV set. The set could tip over, be pushed
off or pulled down from the stand surface and injure someone.
Do not allow the switched-on TV set to run unattended.
- 7 -
Volume
Loud music can lead to ear damage. Avoid extreme volume especially
over long periods and when using headphones.
Thunder storms
Pull out the mains plug and all connected antenna cables from the TV
set in a thunderstorm. Overvoltage caused by lightning can damage the
set via the antenna system, as well as via the mains. The mains plug and
all connected antenna cables should also be pulled out during long
periods of absence.
Note on the LCD screen
The TV set you have purchased with LCD screen satisfies the most rigor-
ous quality requirements and has been inspected relative to pixel errors.
Despite our thorough care when manufacturing the display, it cannot
be 100% guaranteed that no subpixel defects will be present due to
technical reasons. Please understand that these types of effects, as long
as they are within the standard of specified limits, cannot be considered
as a device defect in terms of the guarantee.
Avoid displaying still images for long periods of time. It is possible that
a copy of the image may remain.
Cleaning and care
➠ Switch off the TV set at the main switch before cleaning.
Clean the TV set, the screen, and the remote control unit with a soft,
moist, clean and colour-neutral cloth only, without any aggressive or
scouring cleaning agents.
The speaker panel of your TV set is covered with textile. Vacuum the
surface regularly using a soft brush set.
In case of dirt or stains:
Moisten a soft, colour-neutral cloth with detergent or normal stain
remover and gently rub away the stain. You can also treat the mark/
stain directly with normal dry stain remover spray (vacuum up powder).
Do not moisten the covering fabric directly with detergent or stain re-
mover (risk of encrustation). Do not use any solvents to clean the fabric.
➠ Follow the manufacturer's instructions when using stain removers.
➠ There is an increased risk of encrustation when cleaning speaker
panels with nicotine deposits.