Initial Installation; Installing The Tv Set; Set Covers; Connecting The Tv Set - Loewe Connect ID 46 Operating Instructions Manual

Connect ID 32-46
Operating instructions

Initial installation

Installing the TV set

Mounting options
Your Loewe specialist dealer can assist you in finding other mounting
options that correspond to your needs. Use exclusive Loewe mounting
options (e.g., wall mount, floor stand), which you will find in the chapter
entitled Accessories - Mounting options on page 145.
After you have decided on a mounting option, follow the directions
found in the corresponding assembly instructions.
Installation notes
Choose a place for installing your TV where no bright light or sunlight
shines directly onto the screen. This could cause reflections which
impair the picture.
3 times the screen diagonal can be taken as a guide value for the view-
ing distance (e.g. for 40-inch set approx. 3m for SD signal). The viewing
distance can be reduced with an HD signal.

Set covers

Covers for rear and side connections
To remove the rear cable cover, pull the two recessed handles at the
bottom and drop down the cover.
To fit the cover, insert the lugs at the top edge of the cover into the
corresponding cut-outs in the rear panel and push up the cover until
it snaps in.
The side cover of the TV set can also be completely removed. For this,
open it as far as it will go and gently pull on the open cover.
The cover detaches from the holder and gives free access to the con-
nection area. To replace the cover, simply push it until it latches back
into place.
only for TV sets without DR + .
(1
only for TV sets with DR + .
(2
- 18 -

Connecting the TV Set

Connecting to the mains
Remove the cover for the connections.
Connect the TV set to a 220-240V mains socket:
First plug the small plug of the power cable into the mains connection
on the back of the TV and then the large mains plug into a mains socket.
Connecting antennas
Cable (analogue) / DVB-C / DVB-T antenna:
Plug the antenna cable of antenna, cable system or room antenna into
the ANT TV socket.
If you want to use analogue cables / DVB-C connection and a DVB-T
antenna together, use an external antenna switch (available from your
dealer).
Satellite antenna DVB-S:
If the TV set is equipped with a Single
SAT and ANT-SAT2
(2
Depending on the used satellite system, connect a connecting cable from
the multi-switch or directly from the LNC to the ANT-SAT and ANT-SAT2
sockets of the TV set respectively.
When connecting the TV set to a single cable community antenna,
connect the ANT-SAT and ANT-SAT2 sockets directly to the appropriate
SAT antenna socket.
When connecting the TV set to a DiSEqC single cable community antenna
(in accordance with EN 50494), connect the ANT-SAT socket directly to
the appropriate SAT antenna socket.
➠ A DiSEqC single cable community antenna is also needed on TV sets
with integrated digital recorder (DR + ) and therefore two available
satellite sockets (ANT SAT and ANT SAT2). Further distribution of the
signal to the two reception routes is accomplished by the TV set's
satellite tuner.
Ask your dealer if required.
Cable DVB-T
analogue /
DVB-C
R TV
(1 or Twin (2 satellite tuner, the ANT-
sockets are available.
DVB-S