Loewe Connect ID 46 Operating Instructions Manual page 123

Connect ID 32-46
Operating instructions
External devices
OK continue to set the
Distance to left front speaker.
➠ Measure the distances from your listening position
to the front, surround, and centre speakers respec-
tively. The digital audio decoder calculates delay times
from this for the loudspeaker signals, so that these
reach the listener simultaneously.
SOUND COMPONENTS WIZARD
Please enter the distance of the left front speaker
from your listening position here.
SOUND COMPONENTS
Distance to left front speaker
2 m
Proceed
OK
Set the distance between the left front speaker
and your listening position in 10 cm steps.
OK continue respectively to the other speakers and
adjust the distance.
➠ After setting the distance for the centre speaker ...
OK continue to Adjust speaker level.
SOUND COMPONENTS WIZARD
You hear a sound from every speaker one after
another. But you can also select the speakers
manually with the menu control buttons up/down.
Set the volume for the respectively active speaker
shown in blue so that you get approximately
the same volume impression from
all the speakers.
SOUND COMPONENTS
Adjust speaker level
0 dB
Proceed
OK
Adjust the volume for each speaker.
Select speakers manually.
➠ For balanced audio reproduction all speakers should
be set at the same volume level. A noise signal will be
reproduced automatically on each speaker in succes-
sion. Adjust every speaker to equal perceived volume
from your listening position.
- 123 -
4,2m 2,7m 4,0m
1,0m 0,9m
0dB 0dB
0dB 0dB
Preceding/next loudspeaker
OK continue to Subwoofer phase.
SOUND COMPONENTS WIZARD
Here you can reverse the phase of your subwoofer. Test both values in
music reproduction and then select the one with which you get a better
bass reproduction.
SOUND COMPONENTS
Subwoofer phase
0° 180°
End of wizard
OK
Switch to a station with music with P+/P– or start play-
back with music on a DVD player.
Test both values (0º and 180º) and select the one
with which you get a clearer bass reproduction
from your listening position.
OK to confirm the setting and exit the wizard.
This ends the sound components wizard for connect-
ing and setting up a speakers system.