Loewe Connect ID 46 Operating Instructions Manual page 23

Connect ID 32-46
Operating instructions
Initial installation
Selecting
antennas INITIAL INSTALLATION
Connect antenna cable(s)
Antenna cable(s) for:
Antenna/cable (analogue)
DVB-T
DVB-C
DVB-S (cable 1)
DVB-S (cable 2)
Proceed
OK
Select antenna cable.
Yellow button: Connect/disconnect antenna cable.
Antenna/cable (analogue): analogue stations via
DVB-T:
DVB-C:
DVB-S (cable 1):
DVB-S (cable 2)
Depending on which antenna(s) was (were) selected, the
appropriate settings are called later during the routine.
OK proceed.
Subtitle and
INITIAL INSTALLATION
audio
Subtitle and audio languages (DVB)
languages
Favoured subtitle language
Alternative subtitle language
(DVB)
Favoured audio language
Alternative audio language
Audio commentary
Proceed
OK
Select desired languages and alternative
languages for subtitles and audio for DVB
programmes (see page 61).
Set up audio commentary for the visually
impaired (see page
OK Proceed.
Depending on which antennas (DVB-T, DVB-C,
DVB-S) were selected, the appropriate settings
appear below.
only for TV sets with DR + .
(1
to antenna socket(s):
ANT TV
ANT TV
ANT TV
ANT SAT
ANT SAT2
Connect/disconnect
Back
cable/antenna
digital terrestrial stations
digital stations via cable
digital stations via satellite
(1 : digital stations via satellite
English ...
OK
German
English
German
off
Back
).
43
- 23 -
Setting options for DVB-T reception:
If you have not selected a DVB-T antenna in the antenna selection:
Continue with setting options for DVB-C reception on page 24.
Network If several networks are available over DVB-T, you can
selection decide which network you want to receive your channels
from.
OK Proceed.
Settings
Encrypted You can state whether coded stations are to be searched
stations for in the search/update.
scrambled stations. However, these stations can only
be received in connection with a CA module and the
appropriate Smart Card.
described on page 63.
If a CA module with a SmartCard is already plugged in
for the station search, all the stations which this module
can descramble are also saved when no is preset.
Search
If you want to run the station search independently of
method the channel grid, select frequency search for the search
method.
OK Proceed.
Supply voltage
OK Proceed.
Select network,
INITIAL INSTALLATION (DVB-T)
Scrambled stations no
Search method Channel search
Proceed
OK
Select and adapt settings for DVB-T reception.
Select yes
Handling of the CA module is
INITIAL INSTALLATION (DVB-T)
Antenna
Supply voltage
no (0V)
yes (5V)
OK
Proceed Back
OK
Select supply voltage no / yes.
Use a DVB-T antenna that requires a supply voltage
(active antenna) and which is not already supplied
via a power adapter, then select yes (5V) for the
antenna's power supply.
How to align your DVB-T antenna is described on
page 31.
yes
to save all found