Automatic Update Via The Internet - Loewe Connect ID 46 Operating Instructions Manual

Connect ID 32-46
Operating instructions
Software update
Load new software package
Only the parts of the software package that are not up
to date will be automatically downloaded from the inter-
net and updated.
Each part of the software is downloaded individually from
the internet and is then programmed.
The total time required for all the software parts to be
downloaded from the internet is dependent on the speed
of data transfer that is being used.
The total loading and programming process can take up
to 50 minutes in total.
Please do not switch off your TV set at the mains during
the entire loading and programming process.
SOFTWARE UPDATE
The "TV base software" is being programmed, please wait ...
Note:
The total time required for the loading process from the internet is dependent
on the type of data transfer that is being used:
- up to 125 minutes over a modem (56k)
- up to 110 minutes over ISDN (64k)
- up to 5 minutes over DSL (DSL2000).
The loading and programming process can take up to approx. 50 minutes
in total.
Please do not switch off your TV set at the mains during the entire loading
and programming process.
You will be informed once the loading and programming
process is complete.
SOFTWARE UPDATE WIZARD
The software package has been loaded successfully.
Please switch the TV set off and back on at the mains switch to ensure it is fully
operable.
To make your TV set completely ready for use again,
please turn it off and on again at the mains.
- 133 -

Automatic update via the internet

Your TV set checks at definite intervals whether a newer software than
the one installed in the TV set is available in the Internet. If this is the
case, you can find this out by a screen message.
Showing/Hiding information on new software
MENU: Call TV menu.
no
OK Adopt.
New software found
➠ Yes is selected for Inform about new software.
If the TV set has found a new software version during the check, you
will be informed about this via a screen message.
Load the After confirmation, the new TV software will be loaded
software now from the internet and then programmed.
For more information see left column.
Load software The software will be loaded and programmed after the
when TV set has been switched off into standby mode for the
switching off next time. The display on the control panel (see
to standby page 10) will light up yellow during the update.
The TV set must not be switched off at the mains before
the downloading process is complete (control panel
display lights up red)!
Load software Loading the software will be postponed to a later date.
later (max. The new software message will be displayed the next
3 times time the TV set is switched on.
notification) If the loading process is postponed three times then the
message will only be shown again once the next soft-
ware version is available.
Do not load The new software will not be loaded. The on-screen
this software message will only be shown again for the next software
version version.
Select Settings,
go to the menu line below.
Select Miscellaneous,
go to the menu line below.
Select Software update,
go to the menu line below.
Select Via the internet,
go to the menu line below.
Select Inform about new software.
go to the menu line below.
TV MENU
Settings
Miscellaneous
Software update
Via the internet
Inform about new software
yes
Select yes / no.
Select the desired procedure.