Configuring Epg - Loewe Connect ID 46 Operating Instructions Manual

Connect ID 32-46
Operating instructions
Electronic Programme Guide
Paging through the programme list
P+/P– Page backwards / forwards.
In the entries for Date and Time, you will see changes
in time as well as in date when paging. Scrolling in the
programme list is also possible when the selection is at
the top of the specifications.
Calling additional information about the programmes
➠ Brief information about many programmes is
displayed below the programme list of the broad-
casts.
You can call detailed information with the TEXT button if
this function is offered by the TEXT icon in the lower left.
The symbol explanations are described on page 40.
Programming a recording for a recorder
➠ The selection is in the lower programme list,
if not, press the blue button.
➠ The displayed page of the programme list includes
the desired programme, otherwise browse to it or
suitably limit via the specifications in the lower
section.
Mark the desired programme.
RECORD button: Timer data is called up.
Change or confirm timer data if necessary (see page 126,
"The direct way to record").
Then a red dot will be displayed in front of this
programme as an identification.
RECORD button: Deletes the already programmed record-
ing of the red marked programme from the timer.
- 53 -

Configuring EPG

Start the EPG menu
➠ EPG mode is started,
if not, press the EPG button.
MENU: Call the EPG menu.
Explanations of setting possibilities in the EPG menu:
Station In the station selection you can determine for which
selection station in the programme guide information is to be
displayed. Programme information is only displayed for
stations with
With the coloured buttons you can select or remove sta-
tions or only select the stations from the favourites lists.
Because of the large number of receivable DVB-S stations
you should restrict the station selection. This reduces
the data entry time and increases the clarity in the EPG.
Marking the stations according to reception ranges:
Digital terrestrial stations (DVB-T).
Digital cable stations (DVB-C).
Digital satellite stations (DVB-S).
Data capture Here you can switch the data entry for the electronic
programme guide (EPG) on and off.
If the data entry is switched on, your TV set tries to
update the database overnight (normally between 2
and 5 am) or if required two minutes after switching to
stand-by mode. The TV set must be on stand-by for this
and not switched off at the mains switch.
The indicator on the TV set lights yellow during data
entry in stand-by mode.
The data are also updated while you are watching the
EPG station.
Switch on TV When yes is set, the switched off TV switches on au-
when marked tomatically from the standby mode at the beginning
of a set programme. A screen message appears when
switching on. If this is not confirmed within 5 minutes
with the OK button, the TV switches back off automati-
cally for safety reasons.
Sorting The programmes can be sorted either according to their
start times (chronologically) or according to stations (cor-
responding to station list).
EPG MENU
Station selection Data capture Switch on TV when marked
OK
in the EPG list.
Sorting