DC link components
5.1 Braking Module
5.1.4.4
Installing the Braking Module in a Smart Line Module / Active Line Module / Motor
Module, frame size JX
Figure 5-11
Installing the Braking Module
The steps for the installation procedure are numbered in accordance with the diagram.
1. Insert the Braking Module.
2. Tighten the four retaining screws for the Braking Module.
3. Secure the connection clip to the DC link (DCPA/DCNA) with two screws (Braking Module
NOTICE
Pay attention to the tightening torques
The tightening torques specified in the table "Tightening torques for screw connections"
must be observed.
234
Installing the Braking Module in a Smart Line Module / Active Line Module / Motor
Module, frame size JX
connection) and two nuts (DC-link connection).
Manual, (GH3), 01/2013, 6SL3097-4AE00-0BP3
Chassis power units