Siemens SINAMICS S120 Manual page 8

Preface
Note
Compliance with EMC limit values
The manual describes a target state which, if maintained, ensures the required level of
operational reliability and compliance with EMC limit values.
Should there be any deviation from the requirements in the manual, appropriate actions (e.g.
measurements) must be taken to check/prove that the required level of operational reliability
and compliance with EMC limit values are ensured.
EMC limit values for South Korea
The EMC limit values that have to be observed for South Korea correspond to the limit
values of the EMC product standard for variable-speed electric drives EN 61800-3 of
category C2 or of limit value class A, Group 1 according to EN 55011.
With suitable additional measures, the limit values of category C2 or of limit class A, Group
1, are maintained. Additional measures, such as the use of an additional RFI suppression
filter (EMC filter), may be necessary.
In addition, measures for a correct EMC-compliant configuration of the plant are described in
detail in this manual and the "SINAMICS Low-Voltage Configuration Manual".
Spare parts
You will find spare parts on the Internet at:
http://support.automation.siemens.com/WW/view/en/16612315
Test certificates
The Safety Integrated functions of SINAMICS components are generally certified by
independent institutes. An up-to-date list of certified components is available on request from
your local Siemens office. If you have any questions relating to certifications that have not
been completed, please ask your Siemens contact.
6
Manual, (GH3), 01/2013, 6SL3097-4AE00-0BP3
Chassis power units