Siemens SINAMICS S120 Manual page 306

Cabinet design and EMC
7.1 Information
Note
Notes regarding transportation
• The devices are packaged by the manufacturer in accordance with the climatic conditions
• The notes on the packaging for transportation, storage, and proper handling must be
• For transportation using forklifts, the devices must be set down on a wooden pallet.
• When the devices are unpacked, they can be transported using the transport eyebolts
Note
Prevent the ingress of foreign bodies into the device
When installing the cabinet unit, make sure that no foreign bodies – especially metallic
objects, such as drill swarf, wire end ferrules, or cable cut-offs – fall into the device. If
necessary, cover the ventilation slots.
Note
Comply with all safety regulations
Safety regulations governing shock protection must be observed. See also EN 60204-1.
NOTICE
Only use original Siemens accessories
To ensure that the entire system functions properly, you are advised to use original
Siemens accessories.
Only original DRIVE-CLiQ cables may be used for wiring the DRIVE-CLiQ nodes.
Before commissioning, check the tightening torque of all the terminal screws.
Potentially fatal touch voltage
Cable shields and unused cores/conductors of the power cables must be connected to PE
potential.
Non-observance can cause lethal shock voltages.
304
and stress encountered during transit and in the recipient country.
observed.
attached. The load must be distributed evenly. Chains attached to the transport eyebolts
must only be loaded vertically from above. Heavy blows or impacts must be avoided
during transit and when the devices are being set down, for example.
WARNING
Manual, (GH3), 01/2013, 6SL3097-4AE00-0BP3
Chassis power units