Installing The Braking Module In A Smart Line Module / Active Line Module / Motor Module, Frame Size Hx - Siemens SINAMICS S120 Manual

5.1.4.3 Installing the Braking Module in a Smart Line Module / Active Line Module / Motor
Module, frame size HX
Figure 5-10
Installing the Braking Module
The steps for the installation procedure are numbered in accordance with the diagram.
1. Insert the Braking Module.
2. Tighten the 4 retaining screws for the Braking Module.
3. Secure the connection clip to the DC link (DCPA / DCNA) with 2 screws (Braking Module
NOTICE
The tightening torques specified in the table "Tightening torques for screw connections"
must be observed.
Chassis power units
Manual, (GH3), 01/2013, 6SL3097-4AE00-0BP3
Installing the Braking Module in a Smart Line Module / Active Line Module / Motor
Module, frame size HX
connection) and 2 nuts (DC link connection).
DC link components
5.1 Braking Module
233