Directives; Emc-Compliant Design And Control Cabinet Configuration - Siemens SINAMICS S120 Manual

Components and devices that have been voltage tested according to their product standard
may be disconnected during testing.
The SINAMICS components are voltage tested in accordance with EN 61800-5-1 and are to
be disconnected during this test.
If they cannot be disconnected, input and output terminals must be short-circuited and a
bypass installed. In this case, a DC voltage that is 1.5 times the AC test voltage should be
used for testing.
1) Main circuits are circuits that are electrically connected to the line voltage.
7.1.4

Directives

The product satisfies the protection targets of the following EU Directives applicable within
the European Union:
Table 7- 3 Directives
Directive
2006/95/EC
2004/108/EC
2006/42/EC
7.2

EMC-compliant design and control cabinet configuration

For detailed configuration instructions regarding the EMC-compliant design of drives and
control cabinet configuration, refer to the "SINAMICS Low Voltage Configuration Manual".
Chassis power units
Manual, (GH3), 01/2013, 6SL3097-4AE00-0BP3
Description
Directive of the European Parliament and Council of December 12, 2006 on the approximation of
the laws of the member states relating to electrical equipment designed for use within certain
voltage limits (Low-Voltage Directive)
Directive of the European Parliament and Council of December 15, 2004, which repeals directive
89/336/EEC, on the approximation of laws of the member states relating to electromagnetic
compatibility (EMC Directive)
The directive of the European Parliament and Council of May 17, 2006 on machinery and for
changing Directive 95/16/EC (amendment) (machinery directive)
7.2 EMC-compliant design and control cabinet configuration
Cabinet design and EMC
307