Sartorius FC Operating Instructions Manual page 24

Selecting the Printout Function (
Printout Parameters (Overview)
o factory setting
√ user-defined setting
Setup Application-
Print- defined
output
Automatic
output of
3)
displayed value
Output to
interface port
Line format
ISO/GLP/GMP
printout
Identification
Factory settings:
only printout
1
) = When the scale is used in legal metrology, this setting may be configured for control purposes only; printout of values is not permitted
2
) = Autoprint when load change is >10 d and stability is reached: no printout until residual difference in load value >5 d
3
) = To enable automatic output of the displayed value, the corresponding option ("Automatic output of displayed value") must be activated
under the next menu item at this level, "Output to interface port"
4
) = These settings may not be changed on verified scales
24
PRINTOUT
Stability parameter
Print on request,
then tare
Auto print upon
initialization
(of the application)
Configured printout
FlexPrint
Stability parameter
Stop auto print
Time-dependent
auto print
Serial communication
(PERIPHERALS)
For raw data (16 characters)
ο For other apps/GLP (22 characters)
ο Off
Only for calibration/adjustment
Always on
Lot ID (L ID):
ID1:
ID2:
ID3:
ID4:
No
Yes
)
1)
Without stability
ο With stability
ο Off
On
ο Off
All values
Only main values
See own chapter starting on the next page
ο Off
On
ο Without stability
At stability
Automatic after weight change
Use print key p
ο Not possible
ο 1 display update
2 display updates
4)
10 display updates
4)
100 display updates
ο Application-defined output
Automatic output of displayed value
Enter 20 characters max
ID1
ID2
ID3
ID4
2)