Data Output Functions - Sartorius FC Operating Instructions Manual

Line for metrological data
Bar graph
Measured value line
Text line
Soft key labels
Plus/minus sign Unit/Stability indicator
Tare memory
Calculated value
Application pictograms
Max6200 g
Min 0.5 g
e= 0.1 g
d=0.01 g

Data Output Functions

There are 3 options for data output:
– Output to the display and control unit
– Output to a printer (generate a printout)
– Output to a peripheral device (e.g., computer) via the interface port
Output to the Display and Control Unit
The display is divided into 9 sections. Information about the scale, the application being
used and the sample weighed is output in the following sections:
– Line for metrological data
– Bar graph
– Plus/minus sign
– Measured value line
– Weight unit display, stability symbol display
– Data in tare memory; calculated value
– Application symbol display
– Text line
– Soft key labels
Line for Metrological Data (on scales verified for legal metrology)
This line shows:
– Maximum scale capacity (e.g., 6,200 g)
– Minimum scale capacity; the weight must not go below this limit when the scale is
used in legal metrology
– Verification interval of the scale; irrelevant if the scale is not used in legal metrology
(e.g., 0.1 g)
– Readability: Indicates the actual scale interval (display increment of the scale)
(e.g., 0.01 g)
Bar Graph (overview display)
In the bar graph, weighing results are displayed either
– as a percentage of the maximum scale capacity, or
– in relation to a target value, with tolerance limits indicated.
You can turn off (blank) the bar graph display
(Setup: App: Basic settings: Display: Digit size)
Plus/Minus Sign
This section shows:
– "Busy" symbol
J
– Plus or minus sign
F H
– Zero symbol (indicating the scale has been zeroed)
S
97