Rear Panel Connectors And Switch; Rear Panel Illustrations; Figure 1.2 Rear Panel With Bus Bar - Xantrex XHR 7.5-130 Operating Manual

Features and Specifications

Rear Panel Connectors and Switch

Rear Panel Connectors and Switch
The output terminals for the low voltage models (7.5 V to 40 V) are bus bars. The
high voltage models (60 V to 600 V) use a wire clamp connector. See
Figure 1.3
Use the SW1 Programming, Monitoring, and Shutdown Select switch and the J2
Programming, Monitoring, and Sense connector to choose among several remote
programming and monitoring options. See the following sections for more
information about remote programming:
•
•
•
Rear Panel
Illustrations
Negative Output
(Return) Bus Bar

Figure 1.2 Rear Panel with Bus Bar

18
to identify the switches and connectors on the rear panel.
"SW1 Programming Switch" on page 19
"J2 Programming Connector" on page 20
Section 4. Remote Operation
J2 Programming, Monitoring, and
Sense Connector
(See page 20 for more
information.)
Local Sense Wires
(See page
Positive Output Bus Bar
(See page 39.)
(For 7.5 V to 40 V models.)
48.)
Fan Exhaust Vents
(Do not block.)
Operating Manual for XHR Series Power Supply
SW1 Programming, Monitoring,
and Shutdown Select Switch
(See page 19.)
Blank Subplate
(Replaced if digital programming
interface installed.)
100/120/200/240V
50/60 HZ
1300VA
Ground Screw
AC Input Connector
(See page 36.)
100/120/200/240V
50/60 HZ
1300VA
Figure 1.2 and