Initial Setting Value - Toshiba RSM 100 Instruction Manual

2.8

Initial Setting Value

Item
・The position of Cursor 0
・The position of Cursor 1
・The position of Cursor 2
・The position of Cursor 3
・The active cursor
・The zooming in ratio of the
time axis
・The unit of time to display the
measurement and analysis values
・The relay operating time
・The reference phase (CH)
・The reference phase (phase order)
・The hard copy mode
・The phase difference display
・The unit of time displayed
・The value display
・The fault time calculation at the
data reading

Initial setting value

The fault detection point
The lowest voltage point
The restoration from fault point
0 ms
Cursor 1
The size in which 1 sample of the waveforms fits to
the 1 dot of the screen
The elapsed time from the beginning of the
waveforms
No display
1 ch
Phase A Voltage
Monochrome
Delay display
ms
The secondary values
Execute
⎯ 147 ⎯
6 F 2 S 0 7 1 5
2-35