Toshiba RSM 100 Instruction Manual page 66

•
GR∗∗∗∗-∗∗∗D model and G1IF4: When remote connection
Mode change
button display
Switching during testing
This function is used to block unnecessary alarm output by automatic monitoring A.M.F and to
test measuring elements by other switches.
Click the [Switch] tab to open the screen.
Set A.M.F. to "OFF" to block the automatic monitoring.
Set the related switches to test measuring elements.
Click the [Test on] button, then the settings are transmitted to the relay.
Be sure to reset A.M.F. to "ON" and other switches to "OFF" and click the [Test on] button when
the relay resumes service. If not, the relay may not operate correctly. For safety, the "TESTING"
LED lights in red on the front panel of the relay while both of them are not reset.
Disabling the automatic monitoring prevents tripping from being blocked even if a failure
Note:
should occur in the items monitored by this function.
It also prevents failures from being displayed on the "ALARM" LED and LCD. No events
related to automatic monitoring are recorded, either.
Test mode is invalid
⎯ 65 ⎯
6 F 2 S 0 7 1 5