■Displaying Relative Time
Normally, the position of the active cursor is displayed by the elapsed time from the beginning of
the waveforms while displaying the measurement and analysis values.
This part describes how to display the active cursor position relative to Cursor 0.
《Operating Procedure》
① On the [Measurement] menu, click [Relative Time].
② The active cursor position while displaying the measurement and analysis values
③ To quit the relative time display, click [Measurement], and then click [Relative Time]
2-14
changes to the time relative to Cursor 0.
・ [Relative] is displayed.
・ In the following example, Cursor 1 is the active cursor and it shows that the position of Cursor 1 is 100 ms
from Cursor 0.
Normal Display
(Elapsed time from the beginning of
waveforms)
again.
⎯ 126 ⎯
6 F 2 S 0 7 1 5
Relative Time Display