Your Receiver; Default Pin: 0000; Front Panel; Rear Panel - Strong SRT 7004 User Manual

2.0 YouR RECEIvER

2.1 default PIn: 0000

2.2 front panel

1. usb:
2. lEd display:
3. Power button:
4. standby indicator: Shows power state of the receiver
5. mEnu
6. Remote control sensor:
7. Ch-/Ch+:
8. vol-/vol+
9. ok

2.3 Rear panel

1. Ethernet
2. sAT In
3. sAT ouT
4. s / PdIf coaxial
5. usb
6. hdmI
7. Tv sCART
8. dC power

2.4 Remote Control

1. q
2. !
3. REd
4. gREEn
5. YElloW
6. bluE
4
For connection of USB pen drive for software upgrade storage
devices
Shows channel number in operation and time in Standby
Switch the receiver to Standby or On.
Green LED - receiver is turned on
Red LED - receiver is in standby mode
Open the main menu.
Receives the signal from the remote control
To change channels without using the remote control
Decrease/Increase audio volume.
Confirm settings.
VOL-/VOL+ and CH+/CH- double as navigation buttons when
in menu.
To connect to a network switch, router or modem
To connect to the LNB of your satellite dish for reception of
satellite broadcast signal
To loop through the satellite signal to a second receiver
To connect to a digital or home cinema audio amplifier
For connection of USB device for Multimedia use
To connect to the HDMI input of your TV using a good quality
HDMI cable.
To connect to TV using a SCART cable
To connect to the original included main power adapter (Input
100 ~240V 50~60Hz/ Output 12 V DC
Turns the receiver ON/Standby
To turn the sound on or off.
Flexible functions in OSD menu and Teletext
Flexible functions in OSD menu and Teletext.
Flexible functions in OSD menu and Teletext.
In viewing mode: displays the schedule menu for easy setup
timers; Flexible functions in OSD menu and Teletext.
PART 1 • English
Fig. 1
Fig. 2
Fig. 3