Strong SRT 7004 User Manual page 16

PART 1 • English
note:
7.1.4 Automatic sAT scan
Select the options if you want to do automatic scan.
Satellite:
Transponder:
NIT:
Programme:
Scan Mode:
Blind:
One TP:
Scan Select:
After configuring, press gREEn to start scanning with the selected settings.
Your receiver will now perform an automatic channel search with the scanning progress shown
on screen. During the channel search you can quit the scan process with EXIT or mEnu. When the
progress has been completed, all found channels will be stored and the receiver will switch to the first
found channel.
7.1.5 manual scan - scanning by transponder
Select the options if you want to do a manual scan. (Advanced users.)
Satellite:
Frequency:
Symbol Rate:
Polarity:
NIT:
Programme:
Deleted satellites and transponders from the pre-installed lists can only be
retrieved by performing a factory reset.
Select the satellite you wish to scan, as previously set up in the Satellite Setting
menu.
Select a transponder which is known to carry a signal to check if reception of
the satellite is possible.
Network Information Table. If selected On, the receiver will use the NIT
provided by the satellite provider to search for channels. If selected Off, the
receiver will search with its pre-installed transponder list.
Select Free Only to search for Free to Air channels. Select All to include
scrambled channels as well. Note: Scrambled channels cannot be watched
with this receiver.
Default TP: All stored transponders in the memory will be scanned.
Slow scan in 2 MHz steps. The receiver will first scan the whole frequency
band to find the transponders it can lock on. After gathering all transponders,
it scans the transponders one by one to get all available programmes.
The transponder selected under Transponder will only be scanned.
Select All Sat to search all satellites you have selected in the Satellite Setting
menu. Select Single Sat to search only the satellite selected under Satellite.
Select the satellite you wish to scan from, as previously set up in the Satellite
Setting menu.
Enter a known frequency of a satellite transponder with the 0 ~ 9 buttons on
the remote.
Enter the symbol rate of the previously set satellite transponder with the 0 ~ 9
buttons on the remote.
Set the polarization of the previously set satellite transponder, V (Vertical) or H
(Horizontal).
Select On if you want to do a scan starting from the previously set satellite
transponder according to the Network Information Table, as offered by the
Satellite Provider. Select Off, to scan just the one transponder.
Select Free Only to search for Free to Air channels. Select All to include
scrambled channels as well. Note: Scrambled channels cannot be watched
with this receiver.
13