Specifications - Strong SRT 7004 User Manual

Problem
Bad picture / blocking error
during heavy rain.
Receiver switches off after 3
hours of inactivity of remote
commands
Receiver is suddenly behaving
unexpectedly or erratically, for
example after a mains power
failure, power glitch, lightning
strike near you or after a
(interrupted) software update.
No picture or sound, but
display and green LED are on.
The RCU is not working
No audio, only video
Scrambled service
message
The external USB HDD does
not start.
Password forgotten

9.0 sPECIfICATIons

demodulator
Demodulation:
Input symbol rate:
24
Possible cause
Heavy rain will attenuate
satellite signals, below a certain
level blocking will occur.
Power saving Auto standby
function is activated
Mains power problems could
cause a glitch in software in
rare cases.
HDMI or Scart is not selected
on your TV or Audio Amplifier
TV is not switched on
Battery exhausted
RCU is incorrectly aimed
Audio is muted on receiver,
audio is muted on TV. Audio
Amplifier is muted. Scart cable
is not inserted correctly.
Channel is scrambled.
Power consumption is too
high.
QPSK, 8PSK
DVB-S QPSK: 1 ~ 45 Ms/s
PART 1 • English
What to do
Make sure your dish
installation is up to standards
to minimize rain effects. When
in doubt, ask a local satellite
specialist for advice.
Switch Auto standby function
off, if you don't like it.
Load factory setting from the
System menu.
If not recoverable, ask a local
satellite specialist for advice or
contact local Service Hotline or
send email to our Support via
www . strong . tv
Switch to correct TV input
Switch Audio Amplifier to
correct input
Switch TV on
Change the batteries
Aim RCU at the receiver, or
check that nothing blocks path
to the front panel
Check if audio is muted.
Insert Scart cable properly
Select alternative channel.
Connect an extra power supply
adapter to your USB HDD
device.
Contact local Service Hotline or
send email to our support via
www . strong . tv