Strong SRT 7004 User Manual page 14

PART 1 • English
7.1.1 satellite setting
Press the pq buttons to highlight the satellite your dish is aimed at. Its antenna settings will be
shown at the right side. You can enter the right side with the tu buttons and return to the satellite
list with EXIT. From the Satellite Setting menu, you can start a scan by pressing the gREEn button
after you have made the appropriate settings or edit transponders by pressing the REd button.
7.1.2 Configure the antenna settings for the selected satellite
Satellite
LNB
Transponder
DiSEqC 1.0
Uncommitted
22K Tone
Polarity
Motor
DiSEqC1.2
GOTO X
Location:
Longitude Direction:
Longitude Angle:
Latitude Direction:
Latitude Angle:
SatCR
Position:
The name of the selected satellite is shown here.
The setting is Universal LNB (09750/10600) – the most used on the market.
Select a transponder, known to carry a signal.
Select the switch type in use. 4to1(DiSEqC 1.0) or 16to1. (DiSEqC 1.1)
Select Tone Burst if a Legacy 2to1 switch is used.
If uncommitted DiSEqC switches are used, select them here. (Advanced user
setup)
Press tu to set the LNB power. 13/18V is the setting for a Universal LNB.
Auto: this setting will follow automatically.
13/18V, this setting will follow automatically.
If using a motor, press tu to choose DiSEqC1.2/GOTOX. Then press ok to
show the menu for setting the position for your location.
Move the motor to the right position for locking the signal like explained
below.
Move Continue: press tu for moving West/East. It will keep moving as long
as the button is kept pressed. By pressing once it will move in 1° step.
Move Step(1): press tu for moving West/East in 0.3° step.
Store Position: to store the current motor position for selected satellite.
Goto Reference: to go to the reference 0° position.
Select GOTO X with the tu buttons. Press gREEn to setup your location
coordinates. A pop-up window will appear, in which the following settings
can be made:
Press tu to select one of the pre-set locations. Choose a location nearest to
you. If you know the coordinates of your place of residence, you can choose
Manual and make the following extra adjustments:
Choose East or West.
Press the 0 ~ 9 buttons to enter the coordinate.
Choose North or South.
Press the 0 ~ 9 buttons to enter the coordinate.
When all settings have been made, press EXIT to save the data and leave the
window.
Now press ok to enter the DiSEqC1.3 menu.
Move Auto will move the dish to the selected satellite automatically.
For Move Continue, Move Step (1) and Goto Reference please see explanation
above.
Select On, if you use a SatCR LNB, otherwise leave to Off. When On is selected
press YElloW (Setup SatCR) to enter the Sat setup page.
Select the LNB A or LNB B.
11