Connecting To Ethernet; First Time Installation; Installation - Strong SRT 7004 User Manual

PART 1 • English
1. Connect the LNBs of your fixed antenna to the inputs of a DiSEqC 1.0/1.1 switch
2. Connect the output or "to receiver" connector of the DiSEqC 1.0/1.1 switch to the SAT
IN connector on your receiver.
3. Refer to section 3.1 or 3.2 for TV and mains connections.
4. Refer to section 7.1.1 for Satellite Settings

3.4 Connecting to Ethernet

Connect a CAT5 cable (or higher quality) to the RJ45 connector of the unit and the other end to an
existing switch, router or modem. The default setting is Auto (DHCP) for automatically obtaining IPs
and DNS. Select Manual in Menu NetworkNetwork Settings to enter own settings if required. When
setting up manually, you need to provide a unique IP address, Netmask, Gateway and DNS for your
receiver. Refer to the manual of your router or modem to setup properly. The Ping test can be selected
to check your connecting, once setup correctly.

4.0 fIRsT TImE InsTAllATIon

After all connections have been made properly, switch on your TV and make sure the receiver is
connected to the main power. If you are using the receiver for the first time or restored to factory
default, the Installation menu will appear on your TV screen. Press the tu buttons to select the OSD
Language of your preference.
Country
Pre-installed List
Video Output
TV Format
Start Search
noTE:
You can continue with the Installation menu to scan and install further channels as described below
or go to viewing mode by pressing the EXIT button to start enjoying the pre-installed channels
immediately.

4.1 Installation

4.1.1 satellite setting
Press pq to highlight the satellite your dish is aimed at. When using a multi feed antenna with more
than 1 LNB, select the satellites your antenna is adjusted for by pressing the ok button and set the
appropriate DiSEqC input for the LNBs Astra 19.2E and Hotbird 13E are pre-selected on DiSEqC 1 and
2. The scan process will then search on all selected satellites.
Select your country.
Some countries come with a pre-installed channel list.
If not available for your country, the item is not selectable.
Select the output you prefer to use.
Select between 16:9FIT. 16:9LB and 4:3LB or 4:3PS
If the pre-installed list is selected, the receiver will jump to the first channel in
the list. If no pre-installed list available, the Satellite Setting page will appear.
If Germany is selected as country, a German pre-set channels list from
ASTRA 19.2E will be installed. The pre-installed list will work with a single
Universal LNB (LO 9750/10600). If another type of LNB is used, you need to
setup the LNB in the Installation Menu, Satellite Setting.
Fig. 9
7