Table of Contents
Advertisement
Chapter 1 Using the Operator Panel
5
Press the ENTER key. A blinking question mark (?)
appears.
>Print VMB Data
Tray001?
Press the ENTER key. The document in the mailbox
6
is printed and automatically deleted from the mail-
box after printing is completed.
Printing a List of VMB
A Virtual Mailbox list includes the jobs currently stored in
the mailboxes.
1
Press the MENU key.
2
Press the
or
pears.
e-MPS
3
Press the
key.
4
Press the
or
VMB appears.
>List of VMB
5
Press the ENTER key. A question mark (?) appears.
>List of VMB ?
6
Press the ENTER key again. The printer prints a list
of jobs currently posted in the virtual mailboxes as
shown below. The mailbox (tray) with document(s)
stored is marked with
VIRTUAL MAIL BOX LIST
1-40
key repeatedly until e-MPS > ap-
>
key repeatedly until >List of
in the list.
Changing e-MPS Configuration
You can change the following parameters for e-MPS opera-
tion:
• Maximum number of quick copy/proof-and-hold jobs
• Maximum space assigned to temporary code jobs
• Maximum space assigned to permanent code jobs
• Maximum space assigned to virtual mailboxes
NOTE
The total amount of storage areas specified must not exceed
the total size of the hard disk. Otherwise, you may only be able
to accommodate print jobs of a smaller amount of print jobs
than specified.
Changing the Maximum Number of Quick Copy/
Proof-and-Hold Jobs
This changes maximum number of quick copy/proof-and-hold
jobs from 0 to 50. The default is 32.
1
Press the MENU key.
2
Press the
or
pears.
e-MPS
3
Press the
key.
4
Press the
or
Configuration > appears.
>e-MPS
Configuration
5
Press the
key.
6
Press the
or
Copy appears.
>>Quick Copy
7
Press the ENTER key. A blinking cursor (_) appears.
>>Quick Copy
key repeatedly until e-MPS > ap-
>
key repeatedly until >e-MPS
>
key repeatedly until >>Quick
32
32
Advertisement
Table of Contents
