Table of Contents
Advertisement
Chapter 1 Using the Operator Panel
5
Press the ENTER key. A blinking cursor (_) appears.
>Form Feed
Time Out 000sec.
6
Press the
or
ue of the figure where the cursor is blinking and set
the desired time. The time can be set between 0 and
495 seconds, in 5-second increments. (The printer
does not timeout with the value set to 0.) You can
use the
and
left.
7
Display the desired time and press the ENTER key.
8
Press the MENU key. The message display returns to
Ready.
Turning Off the Sleep Timer
You can turn off the sleep timer function by following the
procedure given below.
1
Press the MENU key.
2
Press the
or
pears.
Others
3
Press the
key.
4
Press the
or
Timer > appears.
>Sleep timer
015 min.
5
Press the
key and display >>Sleep Mode.
>>Sleep Mode
On
6
Press the ENTER key. A blinking question mark (?)
appears.
>>Sleep Mode
? On
1-54
key to increase or decrease the val-
keys to move the cursor right and
key repeatedly until Others > ap-
>
key repeatedly until >Sleep
>
7
Select Off using the
>>Sleep Mode
? Off
8
Press the ENTER key.
9
Press the MENU key. The message display returns to
Ready.
Setting Sleep Timer
The printer has a sleep timer to conserve power when the
printer is not printing, processing, or receiving data. You can
adjust the timer value, the length of time the printer waits
before entering sleep mode in the absence of data.
NOTE
The default setting of the sleep mode is On (enabled).
Press the MENU key.
1
2
Press the
or
pears.
Others
3
Press the
key.
4
Press the
or
Timer > appears. The default setting is 015 min.
>Sleep timer
015 min.
5
Press the ENTER key. A blinking cursor ( _ ) ap-
pears.
>Sleep timer
015 min.
6
Press the
or
ue of the figure where the cursor is blinking and set
the desired time. The timer can be set between 5 and
240 min, in 5-minute increments. You can use the
and
keys to move the cursor right and left.
7
Press the ENTER key.
8
Press the MENU key. The message display returns to
Ready.
or
key.
key repeatedly until Others > ap-
>
key repeatedly until >Sleep
>
>
key to increase or decrease the val-
Advertisement
Table of Contents
