Table of Contents
Advertisement
Setting Auto Continue Recovery Time
Follow the procedure given below to change the recovery
time for Auto Continue.
1
Press the MENU key.
2
Press the
or
pears.
Others
3
Press the
key.
4
Press the
or
Continue Mode > appears.
>Auto Continue >
Mode
On
5
Press the
key and display >>Auto Continue
Timer.
6
Press the ENTER key. A blinking cursor (_) appears.
>>Auto Continue
Timer
030Sec.
7
Press the
or
ue of the figure where the cursor is blinking and set
the desired time. The time must be set between 000
and 495 seconds, in 5-second increments. If set to
000, printing will be continued immediately without
allowing any time interval. You can use the
keys to move the cursor right and left.
8
Display the desired time and press the ENTER key.
9
Press the MENU key. The message display returns to
Ready.
key repeatedly until Others > ap-
>
key repeatedly until > Auto
key to increase or decrease the val-
and
Chapter 1 Using the Operator Panel
1-57
Advertisement
Table of Contents
