Paper Feeder; Du-400 Duplexer; Network Interface Card - Kyocera Mita Ecosys FS-6020 Operation Manual

PF-400 Paper Feeder
PF-400 Paper Feeder can be installed below the printer.
For details of installing the optional paper feeder in the
PF-400 Operation Guide
printer, see the

DU-400 Duplexer

DU-400 Duplexer can be installed to rear of the printer.
For details of installing the optional duplexer unit in the
DU-400 Operation Guide
printer, see the

Network Interface Card

Option network interface card is installed in the option inter-
face slot located at the rear of the printer. Take the following
steps to install option network interface cards. And also refer
to the documentation included with the option.
NOTE
• The network interface card should be installed only by a Kyo-
cera Mita authorized dealer or Kyocera Mita certified techni-
cian. Kyocera Mita shall not be liable for damage due to
improper installation of the network interface card.
• The following instructions are intended for the technician
only.
1 Turn off the printer and disconnect the power cord
and printer cable.
PF-400
.
DU-400
.
2 Remove the screws from the printer's option inter-
face slot cover to remove the cover.
3 Insert the network interface card and secure it with
the screws removed in step 2.
4 Connect the network cable.Then, re-connect the pow-
er cord to the outlet and the printer cable.
5 Turn on the printer and then set the network address
from the printer operator panel (for details about the
modes, see Changing Option Network Interface
Parameters on page 1-44
Appendix B Option Units
).
B-5